Dynatek ignition modules setup sheet

Setup dynatek

Dynatek ignition modules setup sheet


Dyna FS Ignition: DYNA FS: Inst. • setup Heavy- duty billet sheet aluminum construction offers long life dual- fire dynatek with single , kicking • The i operates all modules combinations of single , single fire operation down to zero rpm gives you easier cranking sheet , dual- plug heads, when used with appropriate coils. This is the coil negative wire from the ignition module. sheet PDF reader required. The Panhead & Flathead dynatek Site. You can search the setup threads for speedo inaccuracy and find it. sheet I don' t know about the Dynatek personally dynatek but the modules SE ignition as well as the stock ignition are notorious for being modules inaccurate usually reading dynatek too fast by as much as 5 dynatek mph. The wKB" V- Star 1100 modules Wiki Knowledge Base‎ > ‎ 5 Modifications‎ > ‎ Dyna Ignition Discussions on sheet the forum indicate that the Dyna ignition module had setup little if any benefit unless you had added cams in addition to air intake exhaust mods.

Dynatek FS Ignition Replacement Series Modules User Instructions: DYNA FS:. Ok i modules have attached a picture sheet of my modules Single Fire " dynatek Dynatek" ignition module thats all setup installed in place of the old point and condenser. Find Fusion Products, Maps. These wires are the + 12V setup supply to the coil and the + 12V supply wire to the stock ignition module. Description for setup Dynatek i Ignition. Dynatek ignition modules setup sheet. On the other coil primary terminal, you should find a pink wire from the stock ignition module. same terminal, there Is a second white wire going to the stock ignition module.


Ignition setup

The optional USB interface cable connects to the OE data link connector. This is a four terminal Deutsch connector usually found near the ignition module. The PC link can access the TC88 module when the ignition is turned on and the engine has not yet been started. Once the engine is started, the PC link is disabled.

dynatek ignition modules setup sheet

The DYNATEK Ignition Module for the + Yamaha Rhino 700efi is a piggyback add- on device that will increase the performance of the stock ignition and fuel injection system. This Module is designed to work in conjunction with the stock ECU, and will take complete control of the Ignition Timing while safely extending the fuel injection rev- limit.